Table of Contents Add to my manuals Add. Comments to this Manuals Your Name. It is the responsibility of the customer to determine the suitability of these parts for each application. A list of available hard disk drives will be displayed. If there is no PCC currently inserted in a PC Card slot, a message appears under Windows 95 stating that the operating system has removed, or has not loaded, the PCC device driver. References References This chapter provides a list of the documents referenced in this manual. There are a few design issues which should be taken into consideration when designing an external transceiver pod:
|Date Added:||2 July 2004|
|File Size:||67.37 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
References References This chapter provides a list of the documents referenced in this manual. Cancel This action will cause the New Hardware Found window to be displayed again. PC Card Standard, Release 2. Install the PCC driver software as described below.
Download and install Echelon Corporation LonWorks PCC Network Interface – driver id
References This chapter provides a list of the documents referenced in pcx-10 manual. Microsoft DOS where no Windows operating system is being used. Service The Service button will cause echdlon PCC card to broadcast a service pin message on the network.
This re-initializes the PCC card and allows use of the commands. The post-reset flush state prevents any inbound or outbound network traffic following a reset. Page 17 A list of available hard disk drives will be displayed.
Echelon Network Adaptor 73200r Pcc-10 LonTalk PCMCIA
Testing the card with the Diagnostics button, as suggested by the error message, produces the diagnosis: Hirose CL Figure 4. Whenever a reference document is addressed, a superscript number corresponding to the reference has been placed in the text, i. The information in the Custom Properties area reflects the current configuration within the PCC card. Table Of Contents Windows 3. SYS file which contain the following instructions: Page 2 Parts manufactured by vendors other than Echelon and referenced in this document have been described for illustrative purposes only and may not have been tested by Echelon.
Remove the PCC installation diskette and restart the computer. Enter text from picture: Operation is subject to the following two conditions: Page of 55 Go. Use the arrow keys to select the drive where the PCC Card software should be installed. The default drive is C. This problem can be fixed through the use of device name aliasing. This is accomplished during PCC Configuration. This document has a list of references in Chapter 5.
Page 22 UL Listed equipment. As a result, both types of cards cannot run on a PC at the same time. Ni Application PCC card. Page 13 Page 14 – Windows 3. Network Port Figure 4.
To print the manual completely, please, download it. Don’t have an account?
This action will cause the New Hardware Found window to be displayed again. If the computer does not display blinking options, the highlighted option will be shown as black writing on a white background.
Unlike Windows driver conflicts, this problem is difficult to diagnose. Got it, continue to print.