It will wait for one operation to stop, before the next one starts. The link to the reference manual did not work for me but I have found a copy of the A reference manual here:. Anyway I now that I’m back, here’s what I managed so far:. Also when i include negative voltages in my sweep say like if im sweeping from -2 to 2 then the current values in between go to e-8 range which cannot happen as my resitor value iss 2. What will this interface do? I finally have the connection working properly.

Uploader: Mukree
Date Added: 20 July 2012
File Size: 39.48 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 30080
Price: Free* [*Free Regsitration Required]

You can also use a GPIB interface: It does not take the remaining digits. Message 9 of Message 3 of Perhaps, I was overly sarcastic. And what is its unit?

Keithley A Error Code: – Discussion Forums – National Instruments

What will this interface do? I am setting up a measurement where i need to source a voltage from the keithley and plot keithhley current and resistance.


Message 5 of Also, some of the included sample files give the same error. Like the VISA block. Navigating a new driver can be frustrating if you are not use to the nuiances of vi drives.

I would guess Amps, but read the manual to make sure. This is a 2 channel meter, and my plan is to sweep one channel from 0 to 5 volts and measure the voltage it is sourcing, while the other channel is swept llabview mV to mV so no change in voltaage and measure the current coming through. Now, I try running the Configure Source and Measure.

On my computer – C: Message 2 of It is up to you to pick and choose which functions you want to use. I just had to reconfigure the DUT. Message 5 of 5. Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

Message 7 of Hope that helps somebody!

Search Instrument Driver Network

With the second labvuew, you then connect the two instruments in series with the Keifhley. Message 5 of Most Active Software Boards: I am trying to write a labview program to interface with my A meter via ethernet. Other than that I would check all of the actions that you are performing with the device to see if there are any conflicts where the same resource is needed for several tasks which could bring about an error such as this. As GuentherS said above the waitcomplete command helped me.


If you need assistance on changing the address, please contact service lakeshore.

Message 8 of Anyway, what value does the Advance Sweep return anyway? Anyway I now that I’m back, here’s what I managed so far: Auto-suggest helps you quickly narrow down your search results by keithleu possible matches as you type. The probes were connected to a 2.